Baltobonneville
750cc
Feeler gauge
I found the "go-no go" type in inch dimensions to be the most useful for this job. The metric equivalents are printed on the blades, so there's no conversion problem. Poke it in, if the thin part goes and the thick part doesn't, figure the clearance is halfway between.
Interestingly, the five of mine that were out of spec were all too loose.
I found the "go-no go" type in inch dimensions to be the most useful for this job. The metric equivalents are printed on the blades, so there's no conversion problem. Poke it in, if the thin part goes and the thick part doesn't, figure the clearance is halfway between.
Interestingly, the five of mine that were out of spec were all too loose.