needlejet holder alignment

[rsopp]

Hi,

Changed main jets on my 07 865, loosened the needlejet holder when removing 1 of the jets. In the manual it states to replace needle jet holder as it was before. I did'nt look and now am trying to figure out where it goes. I think I need to align it with something but I don't know what, any help would be appreciated.
Thanks
Bob

 

[nohawk]

Hi,

Changed main jets on my 07 865, loosened the needlejet holder when removing 1 of the jets. In the manual it states to replace needle jet holder as it was before. I did'nt look and now am trying to figure out where it goes. I think I need to align it with something but I don't know what, any help would be appreciated.
Thanks
Bob

Just tighten the holder(emulsion tube) until it seats into the carb body then put the main jet in the same manner, dont tighten to much. You could put the main jet in the holder first and the use a deep socket to put the holder and the main jet in as a unit. No alignment is needed