Recent content by ttbonnie

  1. ttbonnie

    2008 Bonneville 865cc to Custom Bonneville 1100cc

    Auto correct from Dyno - to you know lol didn’t catch it.
  2. ttbonnie

    07-09 Speedmaster questions

    I picked up a 2007 Speedmaster mastercykinder: new through B.B.- Drastic difference on my 6 pot caliper campairsd to stock ! For the money can’t beat it- if i redo the controls i kill upgrade them for sure
  3. ttbonnie

    2008 Bonneville 865cc to Custom Bonneville 1100cc

    Thanks! Can’t wait- what’s the average cost, of dyno on a carbureted bike? Edited the auto spell
  4. ttbonnie

    2008 Bonneville 865cc to Custom Bonneville 1100cc

    Impressive run. I will be putting my bike on a dyno within a couple of weeks
  5. ttbonnie

    WTB steering stabilizer Hinckley Bonneville

    That sucks, hope he’s ok. there are a few cheap/ value brands out there, some cheap ones that are not cheap. thinking on just pulling the trigger on a NH, hoping to find one used ?.
  6. ttbonnie

    07-09 Speedmaster questions

    well we shall see how it goes ?.
  7. ttbonnie

    07-09 Speedmaster questions

    Triumph has really stepped up its game on the controls in later years, allows for a lot customization if need be
  8. ttbonnie

    07-09 Speedmaster questions

    That’s a nice set up! Are those thruxton controls?? I was contemplating a switch if possible. I’m running a free float EBC , with a 6 pot pretech - and definitely need more fluid,
  9. ttbonnie

    WTB steering stabilizer Hinckley Bonneville

    Looking for a stabilizer for a 2007 Bonneville -
  10. ttbonnie

    Any one in AZ???

    Im in the north valley, anyone else around?
  11. ttbonnie

    07-09 Speedmaster questions

    One more question on fitment - would my control cluster mount right to the new master? Or did you need to replace entire control ?
  12. ttbonnie

    07-09 Speedmaster questions

    Thank you rbirkey! Do you feel you should have gone larger?
  13. ttbonnie

    07-09 Speedmaster questions

    I upgraded my front caliper to a pretexh six pot- factory Bonneville (2007) master cylinder has an 11mm bore and doesn’t push enough fluid, imo, to the break. So i would like to replace it with a Speedmaster Master cylinder (which has a 13mm bore- i am under the impression, via ordering...
  14. ttbonnie

    Hello

    Welcome !! Enjoy the madness.
  15. ttbonnie

    Hello again

    Cheers ladies and gents -been a member since 2008 ish, on again off again life gets in the way. About to do more work on my gal, excel wheels upgrade, master cylinder upgrade and a few items cleaned up. And finally a dyno tune since my engine overhaul. Miss the site. Hope all is well. tt..
Top