heloego
New member
My '18 T-100 has a billeted cap on the throttle side held in place with a M6x15, 1.0 thread screw threaded into an insert in the bar. The insert has a M6 threaded hole to accept the screw and a notch outward from the hole to the edge. Looks as though a tool is required to install or remove it.
Is the insert easily removable with the proper tool or is the insert bonded at the factory?
I ask because it will determine which throttle assist I purchase.
Is the insert easily removable with the proper tool or is the insert bonded at the factory?
I ask because it will determine which throttle assist I purchase.
